Mesa YAMAHA Misturador analógico MG 102C

Dimensões: 256.6mm x 62.2mm x 302.5mm Peso: 1,5 kg

Yamaha
Produto indisponível

Quer receber um aviso quando tivermos o produto em estoque?
Preencha os campos abaixo:

DESCRIÇÃO

Dimensões: 256.6mm x 62.2mm x 302.5mm Peso: 1,5 kg

ESPECIFICAÇÃO


 

Electrical Characteristics

      MIN TYP MAX UNIT
Frequency Response ST OUT GAIN: min (CH 1-2, CH 3/4-5/6) 20Hz-20kHz, refer to the nominal output level @1kHz -3.0   1.0 dB
AUX SEND (EFFECT SEND*) -3.0   1.0
MONITOR OUT, REC OUT -3.0   1.0
Total Harmonic Distortion(THD+N) ST OUT +14dBu, 20Hz-20kHz, Input Gain control at minimum     0.1 %
Hum and Noise

Hum and Noise are measured with a 6dB/octave filter @12.7kHz; equivalent to a 20kHz filter with infinite dB/octave attenuation.

input: CH INPUT 1-2 MIC EIN (Equivalent Input Noise): Rs=150Ω, GAIN:max (CH1,2)     -128 dBu
ST OUT ST MASTER CONTROL at nominal level
and all Ch level controls at minimum.
    -87 dBu
AUX SEND (EFFECT SEND*) All Ch AUX controls at minimum     -85 dBu
ST OUT ST Master Control and one CH level control at nominal level (CH1,2)     -64 dBu
ST OUT Residual Output Noise     -100 dBu
Crosstalk (1kHz) Adjacent Input CH 1-2, 1kHz     -70 dB
Input to Output STEREO L/R, CH 1, 2, PAN: Hard left or right, 1kHz     -70 dB
Maximum Voltage Gain (1kHz)

All VR are MAX when measured. PAN/BAL: panned hard left or hard right

Rs=150Ω,
INPUT GAIN: max
MIC to CH INSERT OUT   60   dB
MIC to ST OUT   76   dB
MIC to REC OUT   58.2   dB
MIC to MONITOR OUT   92   dB
MIC to PHONES OUT   81   dB
MIC to AUX SEND (EFFECT SEND*)   76   dB
LINE to ST OUT   50   dB
LINE to AUX SEND (EFFECT SEND*)   47   dB
ST CH 7/8- (9/10**) to ST OUT   26   dB
Rs=150Ω RETURN to ST OUT   12   dB
Rs=600Ω 2TR IN to ST OUT   23.8   dB
Phantom Voltage MIC     48   V
Input HPF   CH 1-2 and CH 3/4-5/6, 80Hz, 12dB/oct
Input Equalization

Turn over/ roll-off frequency of shelving: 3dB blow maximum variable level, +15,-15 dB maximum

CH 1-2 and CH 3/4-5/6 HIGH: 10kHz: shelving
MID: 2.5kHz: peaking
LOW: 100Hz: shelving
CH 7/8-(9/10**) HIGH: 10kHz: shelving
LOW: 100Hz: shelving
Internal Digital Effect*   16 prgrams, PARAMETER cotrol , Foot Switch (effect on/off)
LED Level Meter Pre MONITOR leve 2x7 point LED meter (PEAK,+6,+3,0,-5,-10,-20 dB)
PEAK lights if the signal comes within 3 dB of the clipping level.
Power Supply Adaptor PA-10 AC 38VCT, 0.62A, Cable Length=3.6m
Power Consumption   21 W
Dimensions
(WxHxD)
  256.6mm x 62.2mm x 302.5mm
Net Weight   1.6 kg (MG82CX), 1.5 kg (MG102C)
Option   Microphone Stand Adaptor (BMS-10A), Foot Switch* (FC5)

All VR are nominal when measured. (Nominal position is adjusted to a position that is 6dB lower than the MAX position) Output impedance of signal generator:150ohms
*: EFFECT exists only in MG82CX
**: ST CH IN 9/10 exists only in MG102C

Input specifications

Input Terminals GAIN Actual Load Impedance For Use with Nominal Input Level Connector
Sensitivitiy *2 Nominal Max. before clip
CH IN MIC (1-2) -60dB 3kΩ 50-600Ω Mics -72dBu(0.195mV) -60dBu(0.775mV) -40dBu(7.75mV) XLR-3-31 type *3
-16dB -28dBu (30.8mV) -16dBu (123mV) +4dBu (1.23V)
CH IN LINE (1-2) -34dB 10kΩ 600Ω Lines -46dBu (3.88mV) -34dBu (15.5mV) -14dBu (155mV) Phone Jack (TRS) *4
+10dB - 2dBu (0.615V) +10dBu (2.45V) +30dBu (24.5V)
ST CH MIC IN
(3/4, 5/6)
-60dB 3kΩ 50-600Ω Mics -72dBu(0.195mV) -60dBu(0.775mV) -40dBu(7.75mV) XLR-3-31 type *3
-16dB -28dBu (30.8mV) -16dBu (123mV) -6dBu (389mV)
ST CH LINE IN
(3/4, 5/6)
-34dB 10kΩ 600Ω Lines -46dBu (3.88mV) -34dBu (15.5mV) -14dBu (155mV) Phone Jack *5
+10dB - 2dBu (0.615V) +10dBu (2.45V) +30dBu (24.5V)
ST CH IN (7/8, 9/10 *7) - 10kΩ 600Ω Lines -22dBu (61.5mV) -10dBu (245mV) +10dBu (2.45V) Phone Jack *5
RCA PiN Jack
CH INSERT IN (1-2) - 10kΩ 600Ω Lines -12dBu (195mV) 0dBu (0.775V) +20dBu(7.75V) Phone Jack (TRS) *6
RETURN [L,R] - 10kΩ 600Ω Lines - 8dBu (308mV) +4dBu (1.23 V) +24dBu(12.3V) Phone Jack *5
2TR IN [L,R] - 10kΩ 600Ω Lines -22dBV (79.4mV) -10dBV (0.316V) +10dBV(3.16V) RCA Pin Jack

*1 0dBu is referenced to 0.775Vrms. 0dBV is referenced to 1Vrms.
*2 Sensitivity is the lowest level that will produce an output of +4dB(1.23V), or the nominal output level when the unit is set to maximum level.(all faders and level controls are at maximum position.)
*3 XLR-3-31 type connectors are balanced.(1=GND, 2=HOT, 3=COLD)
*4 Phone jacks are balanced.(Tip=HOT, Ring=COLD, Sleeve=GND)
*5 Phone Jacks are unbalanced.
*6 Phone Jacks are unbalanced.(Tip=Out, Ring=In, Sleeve=GND)
*7 ST CH IN 9/10 exists only in MG102C

Output specifications

Output Terminals Actual Source Impedance For Use with Nominal Output Level Connector
Nominal Max.Before Clip
STEREO OUT [L,R] 150Ω 10KΩ Lines +4dBu (1.23 V) +20dBu(7.75V) Phone Jack *2
AUX SEND
(EFFECT SEND *4)
150Ω 10KΩ Lines +4dBu (1.23 V) +20dBu(7.75V) Phone Jack *2
CH INSERT OUT (1-2) 75Ω 10KΩ Lines 0dBu (0.775V) +20dBu(7.75V) Phone Jack *3
REC OUT [L, R] 600Ω 10KΩ Lines -10dBV (0.316V) +10dBV(3.16V) RCA Pin Jack
MONITOR OUT [L, R] 150Ω 10KΩ Lines +4dBu (1.23 V) +20dBu(7.75V) Phone Jack *2
PHONES OUT 100Ω 40KΩ Lines 3mW 75mW Stereo Phone Jack

*1 0dBu is referenced to 0.775Vrms. 0dBV is referenced to 1Vrms.
*2 Phone jacks are impedance balanced.(Tip=HOT,Ring=COLD,Sleeve=GND)
*3 Phone Jacks are unbalanced.(Tip=Out, Ring=In, Sleeve=GND)
*4 EFFECT SEND exists only in MG82CX
 


 

BUSCA RÁPIDA

Integradores

Curta-nos
no facebook

Av. Benjamin Constant, 937 - São João - Porto Alegre - RS | CEP: 90550-004 Segunda à sexta das 10h às 12h - 14h às 18:30 Sábados das 10h às 12h

TOKMUSIC IM Comercial de Instrumentos Musicais LTDA 06.991.535/0001-58

Topo